The rinse aid dosage is set too low or the rinse aid container is empty.
Replenish the rinse aid, increase the dosage, or change the brand of rinse aid used. Please note that adding too much rinse aid can result in a soapy residue on dishware.
Support for yourDishwashing
Dishwashing
Dishware spotted or not dry
The dishware is not dry or cutlery and glasses are spotted.
Dishware not loaded or unloaded properly.
Load dishware so that the water can drain off freely.
Leave the appliance door (on appliances without automatic door opening) closed for at least 15 minutes. This will allow the residual moisture to evaporate uniformly.
First unload the lower basket, then the upper basket, and finally the cutlery tray (depending on the model). This will prevent water drops from the upper basket and cutlery tray from falling onto the dishware in the lower basket.
The duration of the drying phase for the selected program is not sufficient for the dishware (particularly for plastic dishware).
Select the Extra dry function (depending on the model).
The detergent used does not meet requirements.
On G 1000–G 2000 series dishwashers, it is necessary to select the 2 in 1 or 3 in 1 button as appropriate when using multi-purpose detergents. This has an impact on drying results.
From the G 5000 series onward, the dishwasher automatically detects if multi-purpose detergents were used.
For thorough and gentle cleaning of glasses, dishware, and cutlery, Miele recommends using Miele products.
Only for dishwashers with water softener:
The water hardness of the rinse water is too high.
Fill with dishwasher salt, irrespective of the hardness of the water supply, and set a higher water hardness in the water softener.
The selected program does not include a drying cycle.
Ensure that the selected program includes a drying cycle. If the drying results are unsatisfactory, use other programs.
Operating Instructions finder
Here you will find the operating instructions for your Miele appliances
Find your manual
