The Inlet/drain indicator light on the dishwasher is flashing on and off. There may be water in the wash cabinet. A fault occurred while the water was being supplied/drained.
Ensure that the faucet is fully open.
Please clean the water inlet filter in accordance with the operating instructions.
Ensure that the water inlet hose is not kinked. Remove any kinks or loops from the water inlet hose. Please monitor these points, as the plastic may weaken and the material may tear. In the event of any damage, the water inlet hose must be replaced. Contact Miele Service about this.
Contact the facility manager or a plumber.
Clean the filter combination in accordance with the operating instructions.
A foreign object (such as a cherry pit or a small shard of glass) could be blocking the drain pump and the non-return valve. Remove the foreign object as described in the operating instructions.
Remove any kinks or loops from the drain hose.
Please monitor these points, as the plastic may weaken and the material may tear.
In the event of any damage, the water inlet hose must be replaced. Contact Miele Service about this.
Check the hose for blockages. Try to remove the blockage.
Please ensure that the drain hose can move freely and is not too taut.
If the fault persists, please contact us or book a repair appointment online.
Close the water inlet and disconnect the dishwasher from the power supply (the drain pump will not stop running until this is done).
You can remove the dishware from the dishwasher as normal.
Please contact Miele Customer Service.
