Installing the Wi-Fi module in Gen6000 appliances

The images show where the insertion slot for the Wi-Fi module is located on various Miele@home-enabled appliance models.

Start by using the images to locate the insertion slot on your domestic appliance. If there is no slot, it may be possible for Miele Customer Service to retrofit it. Otherwise, the domestic appliance will not be able to communicate.

1. 

2. Oven: upper right or left-hand side

3. 

4. Coffee machine (built-in appliance, CVA): lower rear right-hand side

5. 

6. Steam combination oven: upper rear right-hand side

7. 

8. Speed oven: upper rear right-hand side

9. 

10. Washing machine, tumble dryer, washer-dryer: lower rear left-hand side

11. 

12. Wine unit: upper rear right-hand side

Proceed as follows to install the Wi-Fi module:

• Disconnect the domestic appliance from the power supply.

• If the appliance is in a housing unit, remove it from the unit and pull it forward until it is possible to access the module slot.

• Remove any stickers from the slot aperture.

• Push the communication module into the slot as far as it will go until it engages.

• Reinstall the appliance if you had removed it.

• Connect the domestic appliance to the power supply.

• You can integrate the appliance into your Miele@home system after around 60 seconds.